Trailing-arm suspension

The trailing arm system is literally that - a shaped suspension arm is joined at the front to the chassis, allowing the rear to swing up and down. Pairs of these become twin-trailing-arm systems and work on exactly the same principle as the double wishbones in the systems described above. The difference is that instead of the arms sticking out from the side of the chassis, they travel back parallel to it. This is an older system not used so much any more because of the space it takes up, but it doesn't suffer from the side-to-side scrubbing problem of double wishbone systems. If you want to know what I mean, find a VW beetle and stick your head in the front wheel arch - that's a double-trailing-arm suspension setup. Simple.





Moulton rubber suspension

This suspension system is based on the compression of a solid mass of rubber - red in both these images. The two types are essentially derivatives of the same design. It is named after Dr. Alex Moulton - one of the original design team on the Mini, and the engineer who designed its suspension system in 1959. This system is known by a few different names including cone and trumpet suspension (due to the shape of the rubber bung shown in the right hand picture). The rear suspension system on the original Mini also used Moulton's rubber suspension system, but laid out horizontally rather than vertically, to save space again. The Mini was originally intended to have Moulton's fluid-filled Hydrolastic suspension, but that remained on the drawing board for a few more years. Eventually, Hydrolastic was developed into Hydragas (see later on this page), and revised versions were adopted on the Mini Metro and the current MGF-sportscar.
Ultimately, Moulton rubber suspension is now used in a lot of bicycles - racing and mountain bikes. Due to the compact design and the simplicity of its operation and maintenance, it's an ideal solution.